HIKVISION DS-K1T981 Series User Manual

2) Set the IP address, subnet mask, and default gateway. Or check Enable DHCP and the system
will allocate the IP address, subnet mask, and default gateway automacally.
5. Click Save.
Report Strategy Sengs
You can set the center group for uploading the log via the ISUP protocol.
Go to Conguraon → Network → Basic Sengs → Report Strategy .
You can set the center group and the system will transfer logs via ISUP protocol. Click Save to save
the sengs.
Center Group
Select a center group from the drop-down list.
Main Channel/Backup Channel
The device will communicate with the center via the main channel. When excepon occurs in
the main channel, the device and the center will communicate with each other via the backup
channel.
Set ISUP Parameters
Set the ISUP parameters for accessing device via ISUP protocol.
Steps
Note
The
funcon should be supported by the device.
1. Click Conguraon → Ne
twork → Advanced Sengs → Plaorm .
2. Select ISUP from the plaorm access mode drop-down list.
3. Check Enable.
4. Set the ISUP version, server address, device ID, and the ISUP status.
Note
If you select 5.0 as the version, you should set the ISUP key as well.
5. Click Sa
ve.
Plaorm Access
Plaorm access provides you an opon to manage the devices via plaorm.
Steps
1. Click Conguraon → Ne
twork → Advanced → Plaorm Access to enter the sengs page.
2. Select the Plaorm Access Mode.
DS-K1T981 Series Access Control Terminal User Manual
84

HIKVISION DS-K1T981 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T981 Series
Category	Touch terminals
Language	English