HIKVISION iDS-7700NXI-I4/16P/16S Series - Configure the Linkage Action and Arming Schedule; Configure OSD

8.2 Congure the Linkage Acon and Arming Schedule
Congure the linkage acons and arming schedule for access control or alarm devices. Linkage
acons will be triggered when the designate alarm occurs.
Steps
1. Click of an added IoT device.
Figure 8-5 Congure IoT
2. Select Event Type. The following conguraon is only valid for the selected event type.
3. Check Enable.
4. Check linkage
acons as your desire. For detailed steps, refer to Congure Linkage Acons .
Note
Full Screen Monitoring and OSD Display are only valid for the selected Trigger Channel.
5. Click Arming Schedule.
6. Congure arming schedule. For detailed steps, refer to Congure Arming Schedule . Linkage
acon is only valid during the set schedule.
7. Click Apply.
8.3
Congure OSD
You can display alarm informaon received from IoT devices on live view image.
Steps
1. Click of an added IoT device.
2. Check OSD Display on Event
Conguraon interface.
3. Select Trigger Channel.
4. Click OSD Display
Conguraon.
Network Video Recorder User Manual
116