HIKVISION iDS-7700NXI-I4/16P/16S Series - ISAPI Service; HTTP Authentication; IP Camera Occupation Detection

15.12.4 ISAPI Service
ISAPI (Internet Server Applicaon Programming Interface) is an open protocol based on HTTP,
which can realize the
communicaon between the system devices (e.g., network camera, NVR,
etc.). The device is as a server, the system can nd and connect the device.
Steps
1. Go to System → System Service → System Service .
2. Check Enable ISAPI.
3. Click Apply.
4. Restart the device to take
eect the sengs.
15.12.5 HTTP
Authencaon
If you need to enable the HTTP service, you can set HTTP authencaon to enhance access
security.
Steps
1. Go to Maintenance → System Service → System Service .
Figure 15-23 HTTP
Authencaon
2. Check Enable HTTP.
3. Select HTTP
Authencaon Type.
Note
Two authencaon types are selectable, for security reasons, it is recommended to select digest
as the authencaon type.
4. Click Apply to save the sengs.
5. Restart the device to take eect the sengs.
15.12.6 IP Camera
Occupaon Detecon
Aer enabling the feature, when search IP camera in Number of Unadded Online Device interface,
the status of IP camera the has been added by other device will show as
Steps
1. Go to System → System Service → System Service .
2. Check Enable IP Camera Occupaon Detecon.
3. Click Apply to save the
sengs. And reboot device to take eect the sengs.
Network Video Recorder User Manual
184