HIKVISION iDS-TCD403-BI - 4.1.6 Set Cloud Storage

When the overlaid number digits are smaller than the xed digits, 0 will be overlaid before
the overlaid number. E.g., the xed digits for lane No. is 2. If the lane No. is 1, 01 will be
overlaid on the picture.
Overlay Plate Close-up
Check it to overlay license plate close-up pictures on the captured pictures.
4. Select the overlay
informaon from the list.
Note
The overlay informaon varies with dierent models. The actual device prevails.
5. Set the overlay informaon.
Set Type You can edit the type.
Set Overlay
Informaon
For some informaon type, you can edit the detailed informaon.
Set Overlay Posion If you check it, the current informaon will be displayed from a
new line.
Set Space Number Edit the number of space between the current informaon and the
next one from 0 to 255. 0 means there is no space.
Set Line Break
Characters
Edit the number of characters from 0 to 100 between the current
informaon line and the previous informaon line. 0 means no
line break.
Adjust overlay
sequence
Click / to adjust the display sequence of the overlay
informaon.
6. Click Save.
2.2.3 Set Image Encoding Parameters
If the captured pictures are not clear, set the resoluon of the captured pictures and the picture
size.
Steps
1. Go to Conguraon → Device Conguraon → Encoding and Storage → Image Encoding .
Figure 2-5 Set Image Encoding Parameters
2. Select Capture Resoluon.
3. Enter the picture size.
JPEG Picture Size
The size of the captured picture.
Network Trac Camera (for Trac Flow Camera) User Manual
8