HIKVISION iDS-TCD403-BI - 6.2 Connect to Platform; 6.2.1 Connect to ISUP Platform

The higher the gamma correcon value is, the stronger the correcon strength is.
Brightness
It refers to the max. brightness of the image.
Contrast
It refers to the contrast of the image. Set it to adjust the levels and permeability of the
image.
Shuer
If the shuer speed is quick, the details of the moving objects can be displayed beer. If the
shuer speed is slow, the outline of the moving objects will be fuzzy and trailing will appear.
Gain
It refers to the upper limit value of liming image signal amplicaon. It is recommended to
set a high gain if the illuminaon is not enough, and set a low gain if the illuminaon is
enough.
3D Noise
Reducon Mode
Digital Noise Reducon (DNR) reduces the noise in the video stream.
In Normal Mode, the higher the Noise Reducon Level is, the stronger the noise will be
reduced. But if it is too high, the image may become fuzzy.
In Expert Mode, set Space Domain Intensity and Time Domain Intensity. If the space
domain intensity is too high, the outline of the image may become fuzzy and the details may
lose. If the
me domain intensity is too high, trailing may appear.
2D DNR
The higher the 2D DNR Level is, the stronger the noise will be reduced. But if it is too high,
the image may become fuzzy.
Enable Slow Shuer
You can enable slow shuer to increase the exposure me and raise the photosensivity.
Then the image brightness can be raised in low illuminaon condions.
Video Standard
Select the video standard according to the actual power supply frequency.
5.3 Set ICR
ICR adopts mechanical IR lter to lter IR in the day to guarantee the image eect, and to remove
the IR lter at night to guarantee full-spectrum rays can get through the device.
Steps
1. Go to Conguraon → Device Conguraon → Image Parameters → ICR .
2. Select ICR Mode.
Auto-Switch
Switches to ICR mode automacally at night or in dark light condions.
Network Trac Camera (for Trac Flow Camera) User Manual
23