HIKVISION iDS-TCD403-BI - 4.1.2 Set FTP

Chapter 2 Capture Conguraon
2.1 Set Data Collecon
You can set the vehicle data collecon and analysis parameters.
Steps
1. Go to
Conguraon → Device Conguraon → Applicaon Mode → Trigger Mode .
2. Select Trigger Mode as Data Collecon.
Figure 2-1 Set Data Collecon
3. Select Linked Lane Amount.
4. Select data upload mode.
Upload Real-Time Data
The device will upload the collected data to the server in real
me.
Upload Stascs Data
The device will upload the collected data to the server according to the set interval.
5. Select Protocol Type.
Unicoil
Network Trac Camera (for Trac Flow Camera) User Manual
4