HIKVISION iDS-TCD403-BI - Set SNMP; Set Image and Video Library

If you use EAP-MD5, the authencaon server must be congured. Register a user name and
password for 802.1X in the server in advance. Enter the user name and password for
authencaon.
EAPOL Version
The EAPOL version must be idencal with that of the router or the switch.
4. Enter User Name and Password registered in the server.
5.
Conrm the password.
6. Click Save.
6.5 Set SNMP
You can set the SNMP network management protocol to get the alarm event and
excepon
messages in network transmission.
Before You Start
Download the SNMP soware and manage to receive the device informaon via SNMP port.
Steps
1. Go to Conguraon → Device Conguraon → System → SNMP .
2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
• The SNMP version you select should be the same as that of the SNMP
soware.
• Use dierent versions according to the security levels required. SNMP v1 is not secure and
SNMP v2 requires password for access. SNMP v3 provides encrypon and if you use the third
version, HTTPS protocol must be enabled.
3. Set the SNMP parameters.
4. Click Save.
6.6 Set Image and Video Library
Set the interacon parameters of the device consistent with those of the image and video library
plaorm via the image and video library (1400) protocol, and register the device on the plaorm.
When the device generates alarm signals, the alarm informaon will be sent to the plaorm.
Steps
Note
The funcon varies with dierent models. The actual device prevails.
1. Go to Conguraon → Device Conguraon → System → Image and Video Library .
2. Check Enable.
3. Set the parameters such as the device ID, user name, password, etc.
Network Trac Camera (for Trac Flow Camera) User Manual
31