HIKVISION iDS-TCD403-BI - Chapter 10 Maintenance; 10.1 View Device Information; 10.2 Log; 10.2.1 Enable System Log Service

3. Click OK.
10.6 Synchronize Time
Synchronize the device me when it is inconsistent with the actual me.
Steps
1. Go to
Conguraon → Device Conguraon → System → Time Sengs .
2. Select Time Zone.
3. Select Time Sync. Mode.
NTP Time Sync.
Select it to synchronize the device
me with that of the NTP server. Set Server Address, NTP
Port, and Interval. Click NTP Test to test if the
connecon between the device and the server
is normal.
Manual Time Sync.
Select it to synchronize the device me with that of the computer. Set me manually, or
check Sync. with computer
me.
SDK
If the remote host has been set for the device, select it to synchronize me via the remote
host.
ONVIF
Select it to synchronize me via the third-party device.
No
Select it to disable me synchronizaon.
All
Select it, and you can select any mode above.
Note
The me synchronizaon modes vary with dierent models. The actual device prevails.
4. Click Save.
10.7 Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
funcon.
Steps
1. Go to Conguraon → Device Conguraon → System → DST .
2. Check Enable DST.
3. Set Start Time, End Time, and DST Bias.
Network Trac Camera (for Trac Flow Camera) User Manual
42