199253
(6) -
EN
-
Accella™ Therapy Mattress Instructions for Use Page 21
Installing the Patient
9. Attach the control pendant to the footboard of
the bed using the handle attachment (A).
10. Open the zip fastener of the upper cover on the
left at the foot of the bed. Pass the cord through the hole in the middle on the
left-hand side and put the power cord under the lower mattress and the
connector as shown below, making sure that it is secured by the safety clamp
(B).
Check that the clamps of the power supply cord are attached to the
main frame, and not to articulated parts, such as the head or foot
sections, and close the cover. Failure to follow this recommendation
could result in damage to the equipment.
Take care not to damage the power cord when moving the bed. Failure
to follow this recommendation could result in corporal injury.
11. Connect the power cord to the wall outlet.
Ensure that the wall outlet is freely accessible after installation of the device.
12. Make sure the CPR button is not pressed (CPR indicator light off).
The mattress inflates as soon as it is switched on and automatically
switches to the ALP
/ MCM™*
mode at the end of the initialization
cycle. The mattress takes approximately 20 minutes to inflate.
13. Do not place the patient on the mattress during the initial inflation
phase and until the ALP mode activation. The operator must check that
all the zones of the mattress are fully inflated before installation.
14. For small patients, center the sacrum on the
I-mmersion
™
Therapy zone
marked on the mattress cover.
The control pendant continuously diplays the status of the device.
To Next Page
Loading...
Need help?
General
