Page 34 199253
(6) -
EN
-
Accella™ Therapy Mattress Instructions for Use
Transferring the Device from One Bed to Another
Never leave the patient on the device during transfer.
Make sure that the bed chassis brakes are applied to prevent any
accidental movements.
Standalone version*
1. Activate the maximum inflate mode and wait for 1 minute, until the
mattress is firm.
2. Place the control pendant between the two layers of the mattress to prevent it
from being damaged.
3. Undo the two straps that secure the mattress to the bed (at the head and foot
ends).
4. Disconnect the power cord from the wall outlet, and place it on the mattress.
To handle the mattress, Hill-Rom recommends the intervention of two
persons.
5. Transfer the mattress onto the other bed.
6. To install the mattress on the other bed, follow the installation procedure
(page 20) from step 4.
Mattress combined with the Accella™* bed
1. Perform steps 1 to 8 of the deflation procedure (page 36).
Hill-Rom recommends that two people should handle the mattress.
2. Transfer the mattress onto the other bed chassis.
3. To install the mattress on the other bed, follow the installation procedure
(page 22), from step 4.
To Next Page
Loading...
Need help?
General
