199253
(6) -
EN
-
Accella™ Therapy Mattress Instructions for Use Page 27
Mobilizing and Securing
the Patient
Combined mattress
Refer to the bed’s manual for the activation and control of the different
therapeutic modes.
Activating the CPR
Standalone version
In emergencies, opening the CPR valve (cardiopulmonary resuscitation) quickly
deflates the mattress, providing a hard surface for external heart massages.
Do not allow unqualified persons to activate this function. Ensure that no
obstacles (e.g., limbs, accessories, objects, power cords) or persons are
under the head section.
1. Press the CPR button located on the control pendant.
The light indicator near the CPR symbol turns green.
The mattress deflates in approximately 30 seconds.
2. If necessary, lower the siderails and the head section of the bed, or place the
bed frame in the CPR position (refer to the instructions of the bed
manufacturer).
3. Place a CPR board under the patient, or follow the protocol of the CPR
function.
Cancel the CPR
1. Press on the CPR button again.
In view of the damage that this emergency function can cause, the mattress
restarts by completing an initial inflation cycle. The mattress reverts to the
preceding therapeutic mode.
2. If necessary, place the bed frame in the appropriate position (refer to the
instructions for the bed frame).
The CPR function can only be activated when the mattress is connected to the
mains and is ON, and for the first 2 hours when in transport mode.
The mattress should be plugged into a wall outlet so that it inflates.
Combined mattress
Refer to the bed’s manual for the activation and control of the CPR function.