10
Hills – ComNav User Manual V1.3 www.das.com.au
Accessing the ComNav – Via a Touch Tone Phone
This section describes how to access the ComNav via an off site touch-tone phone. The ComNav
must be on an independent line to the touch-tone phone from which you are trying to connect. The
ComNav must be pre-programmed by your security service provider to automatically answer the
incoming call once the predetermined number of calls / rings have been reached. When the desired
number of calls / rings has been reached the ComNav will grab the Phone Line and a connection
has been established, the following will be announced.
; Enter your code for system access, press star to cancel
Enter your user / master code (default master code is 1234), the ComNav will announce the
recorded system name (if recorded) and list all accessible main menus, you can now make your
selection as required.
; You are now connected to (system name)……
Press 1 for system status
Press 2 for system control
Press 3 for intercom control
Press 4 for output control
Press 5 for message bank
Press 0 for system configuration*
Press # to exit and disconnect the session
* Denotes master
code access only
The above sequence will be shown through out this manual as
[PIN]
To Next Page
Loading...