42
Hills – ComNav User Manual V1.3 www.das.com.au
Output Name – Voice Recording
How to: Record an output name
Step Example
To record a output name, and add this new recording to connected
VoiceNav code pads.
1.
[PIN]
Call the ComNav via an offsite touch-tone phone to begin the session.
2.
Press [0] for system configuration menu
Press [6] for voice message recording
Press [6] to record or configure a output name
3.
Select a output number to record or configure, followed by #. (from 1~ 16)
4.
Press #, to record a new output name
5.
Record 3 second output name after the beep
6.
1
st
star, moves back to step 4, (select a output number to record)
2
nd
star, moves back to voice message recording menu
3
rd
star, moves back to main menu
Output Name – library word configuration
To configure an output name using words from the word library (page 55) instead of recording your
own voice, replace steps 4 and 5 above with the following steps. Example: East side light
Up to eight library words can be strung together to achieve your desired phrase.
4.
Press [2], To configure a new zone name
5
Select library word one, followed by #. (EG: East = word 58)
Select library word two, followed by #. (EG: Side = word 125)
Select library word three, followed by #. (EG: Light = word 95)
Note: If your system is configured with VoiceNav code pads, you will be prompted to either copy
changed recordings or copy all recordings when exiting this menu. Copy changed recordings, will
only add the latest recordings whilst selecting copy-all recordings will overwrite all recordings, new
and old. Please contact your security provider to verify how your system is configured.
For multiple recordings, press * once at step 6, which will take you back to step 4, this will allow
additional recordings without exiting the system
To Next Page
Loading...