12
Hills – ComNav User Manual V1.3 www.das.com.au
Main Menu – explained
- System Status
Press [1] to hear the current status of the security system. Please refer to table on page 53 & 54 for
a complete list of system status messages.
- System Control
Press [2] to access the System Control menu, this menu allows easy everyday operation of the
security
system, from arming and disarming individual or multi area systems to bypassing (isolating
/ excluding) individual zones as required. The internal 185 event log is also accessed from this
menu.
-
Security System Status – Refer to status message table on page
53 & 54
- Area Control – This is where areas are armed / disarmed (turned on / off) from either
the away or stay modes
- To Control Zone Bypass – This is where zone/s are isolated (disabled) and
removed from the security systems arming cycle
-
Event History – This is where the last alarm can be viewed, or the last
185 events,
which are stored in the panel’s internal log
- To move back to the main menu
- Intercom Control
Press [3] to access intercom control. An intercom call can be initiated from any external touch-tone
phone and a connection established with the outdoor station, individual VoiceNavs or all
VoiceNavs. Two-way communication is “voice switching”, only one person may speak at any time
and the caller has priority. Switching between caller and called parties is automatic, and is
controlled by silence on the caller’s microphone.
- To commence listen in mode – Allows for a remote user to connect and listen in to
front door stations / VoiceNavs.
- To commence two – way communication mode – Allows for a remote user to
connect and engage in a two-way voice call with a front door stations / VoiceNavs.
- To move back to the main menu
To Next Page
Loading...