Hills DAS ComNav - System Configuration; Voice Message Recording

37
Hills – ComNav User Manual V1.3 www.das.com.au
Menu 0 - System Configuration
0.1 User Configuration
0.2 Time & Date
0.3 Area Entry Time
0.4 Area Exit Time
0.5
Phone number configuration

0.6 Voice message recording
0.6.1
To record an exit message
0.6.2
To record an entry message
0.6.3
To record a user name
0.6.4
To record or configure a zone name
0.6.5
To record or configure an area name
0.6.6
To record or configure an output name
0.6.7
To record or configure a room name
0.6.8
To record a system name
Voice message recording
This is the recording centre for user names, zone names, area names, output names, room names
and system names. The voice message-recording menu also offers an alternant location for the
recording of entry and exit messages (previously described under menu 5 – Message bank).
Once recorded, a system name will be announced every time a new dial in session is established
with the ComNav. This is ideal when monitoring multiple sites.
Apart from voice recordings, zones, areas, outputs and rooms can be configured using pre-
recorded words from the word library. You may string up to eight words together to achieve your
desired description.
Please note that voice recording is limited to the first 64 zones, pre-recorded library words must be
used for all additional zones above zone 64.