Hills DAS ComNav - System Configuration; User Configuration; Time and Date Configuration; Area Entry Time Configuration

14
Hills – ComNav User Manual V1.3 www.das.com.au
- System Configuration
Complete customisation of your security system is achieved through this menu. Entry and exit
times can be adjusted to suit the individual requirements of the system. You can record names
against users, zones, areas, rooms and outputs creating an extremely user-friendly security
system. You can also enter / delete the three alarm phone numbers, SMS numbers, and call divert
numbers.
Note: voice recording is limited to the first 64 zones. Zones 65 and above can be customized using
only library words.

- User configuration -
Here you can create PIN codes and assign them to users. A user PIN code is used to arm and
disarm areas within your security system. PIN codes are normally 4 digits, however a 6-digit option
is available for increased security. Once you have created PIN codes you will need to assign which
areas they have access to. For example you may only want a particular users to access selected
areas in your security system. Here you can also select User Authority options for each user - this
includes creating Master PIN codes. Note - Master Codes can only create, delete or modify user
codes with equal or less authority than themselves.
To Configure

- User PIN

- User Area

- User Authority

- To move back to System Configuration menu.

- Time and date - System time and date is set here. The ComNav has a built in real
time clock that will keep accurate time in the event of a total power fail. It will also update
its time from the internet (if connected) on a regular basis.

- Time

- Date

- Area Entry time - Independent entry times can be assigned for up to eight areas,
values are from 10 seconds to 255 seconds

- Area Exit time – Independent exit times can be assigned for up to eight areas,
values are from 10 seconds to 255 seconds