Hioki 3522-50 - Page 34

20
────────────────────────────────────────────────────
3.3 Basic Measurement
────────────────────────────────────────────────────
Ten Key Screen
Ten Key Screen
Initial Screen
NOTE
3. Press the keys
, ,and
in
succession on the ten key pad.
If you make a mistake, press the
key to
clear the value entered so far, and start again.
Then press the key, and check that the
test frequency value input is indeed 120 Hz.
The numerical value input for the test
frequency cannot be checked until one of the
keys
, ,and
has been pressed.
If you press the key before pressing the
key, the display will return to displaying
the Initial screen with the previously set value
for the test frequency still current.
4. When the setting has been established as
above, press the key, and the display will
return to the Initial screen.
For details, refer to Section 4.3, "Setting the Test
Frequency".