Hioki 3550 - Chapter 4 Standard Measurement; Preparing for Measurement

17
___________________________________________________________________
Chapter 4 Standard Measurement
___________________________________________________________________
WARNING
To avoid electric shock when replacing the batteries,
first disconnect the leads from the object to be
measured.
Do not mix old and new batteries, or different types
of batteries. Also, be careful to observe battery
polarity during installation. Otherwise, poor
performance or damage from battery leakage could
result.
After replacing the batteries, replace the cover
before using the product.
Chapter 4
Standard Measurement
4.1 Preparin
g
for Measurement
1. Remove the battery cover.
2. Insert the batteries into the battery compartment as shown in
the figure below.