v
___________________________________________________________________
Precautions
___________________________________________________________________
DANGER
The floating voltage between input terminals and
ground is 450V DC/AC. Attempting to measure
voltages exceeding 450V with respect to ground
could damage the product and result in personal
injury.
When voltages higher than 30 Vrms, 42.4 Vpeak or
battery circuits with more than 60 VDC are to be
measured, be sure to establish the floating state
first. Carrying out such measurements in the
grounded state involves the risk of electric shock.
When measuring batteries, always ensure sufficient
ventilation. Sometimes sparks may occur when the
test leads are connected to batteries, which can
ignite any accumulated inflammable gases such as
hydrogen.
To avoid electric shock accidents, when measuring
batteries being charged wear proper protective gear
such as rubber gloves.
WARNING
Do not allow the product to get wet, and do not take
measurements with wet hands. This may cause an
electric shock.
Do not use the product where it may be exposed to
corrosive or combustible gases. The product may be
damaged or cause an explosion.
Precautions
Follow these precautions to ensure safe operation and to
obtain the full benefits of the various functions.
To Next Page
Loading...
