110
Replacing the Test Lead’s Tip Pin
9.6 Replacing the Test Lead’s Tip Pin
The conductive-tip contact pin is replaceable. Replace the pin with
a new one if it is broken or worn. One-piece conductive-tip contact
pins with a plastic pin base (model 9465-90 Tip Pin) is available
separately.
For model 9465-10
1
Turn off the instrument and remove the test lead.
2
Unscrew the cable lock to unlock the cable.
1
2
To prevent broken wires;
do not pull or twist the
cable.
The cable is locked by screwing the cable lock.
3
Hold the tip pin base so that the cable won’t rotate, and
then rotate the grip to loosen it.
1
2
3
Hold the tip pin base tightly.
Beware of injury since the tip has a sharp point.
4
Pull off the connector and remove the tip pin.
9465-90 Tip Pin
Do not apply a load to the cable to
prevent broken wires.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
