Hioki BT3554 - Appendix; Appx. 4: Effects of Current Density

111
Replacing the Test Lead’s Tip Pin
5
Fasten a new model 9465-90 Tip Pin. Press the tip of the pin
against a hard board so that the pin won’t spring out, and
push the connector onto the pin.
9465-90 Tip Pin
6
Assemble the tip pin in the reverse order of disassembling.
Catch
Bush
To prevent broken wires, fasten the bush
approx. 1 mm higher than the catch. Be
careful not to push the bush too deeply.
Do not pull or twist the cable.
7
To avoid broken wires and contact failures, after tightening
the cable lock, gently tug and twist the cable to check that
LWLV¿UPO\KHOG
8
Check the performance.
Measure an object to make sure that the measured resistance is correct
before using it.
1
2
3
4
5
6
7
9
Appx.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com