Hioki DT4282 - Cable Handling and Safety

11
Usage Notes
Handling the cables
WARNING
To prevent electric shock, when measuring the
voltage of a power line use a test lead that satises
the following criteria:
• Conforms to safety standards IEC 61010 or EN 61010
• Of measurement category III or IV
• Its rated voltage is higher than the voltage to be
measured
All of the optional test leads for this device conform
to the safety standard EN 61010. Use a test lead in
accordance with its dened measurement category
and rated voltage.
CAUTION
• Avoid stepping on or pinching the cable, which could
damage the cable insulation.
• To avoid damaging the cables, do not bend or pull the
leads and the probe bases.
The ends of the test leads are sharp. Be careful to avoid
injury.
For the test leads supplied with the instrument or the options to be connected
to the instrument, see the following information.
Accessories and options Reference
Test lead “2.3 Using Test Leads” (p. 28)
Thermocouples (K) “3.8 Measuring Temperatures” (p. 45)
Clamp-on probe
See the Instruction Manual which
accompanies the optional clamp.
USB cable “4.13 Communicating with PC” (p. 72)
Magnetic strap
“2.4 Installation in Measurement
Location” (p. 31)
1
Ind.Appx.
7
6
5
4
3
2
HIOKI DT4281A981-08