Hioki DT4282 - Checking the Peak Value (V • APEAK)

62
Checking the Peak Value (V • A PEAK)
4.6 Checking the Peak Value (V • A
PEAK)
After starting the voltage/current peak measurement, the maximum/
minimum instantaneous value can be checked.
The peak measurement can be performed only with the manual
range. Press RANGE to select the appropriate range before
starting the measurement. (For the range conguration and
display range, see page 84)
COPY: MEAS_DC-ACV
COPY: MEAS_
DC+ACV
COPY: MEAS_DCVCOPY: MEAS_ACV
コンダクタンス（Ｓ）ダイオード導通
PEAK
交流電流ＡＣＡCOPY: MEAS_DCuA温度ＴＥＭＰ静電容量（Ｃ）
Maximum
instantaneous
value
Minimum
instantaneous
value
Press .
The maximum/minimum
instantaneous value can be
retained, from the point at which
is pressed.
To cancel the display of the peak
value, press it again.
• A buzzer sounds when PEAKmax or PEAKmin is updated.
• If you start peak measurement using the 60 mV range or 600 mV range,
such a range switches over to the 6 V range.
Clearing the maximum/minimum instantaneous value
Press
.
The maximum/minimum instantaneous value can be displayed, from the point
at which
is pressed.
HIOKI DT4281A981-08