Hioki DT4282 - Resetting the System; Table of Default Settings

76
Resetting the System
4.15 Resetting the System
The system is returned to the state before shipping. The power-on
option setting is also reset.
The memory data are not reset. To clear the memory data, clear
the data individually for each memory No. (p. 68) or clear all data
(p. 68). The temperature unit is not reset, either.
TEMP C
TEMP FVERSION
RESET
０－２０mA電源遮断断線（Ｋ熱電対）####
オートパワーセーブＯＦＦブザーＯＦＦメモリデータクリアメモリデータなし
1
Turn on the power while pressing
and .
2
Within 3 seconds, press
again.
After [CLr] blinks, the system returns to the
state before shipping.
If the instrument is not operated for 3 seconds,
the system is not reset but the measurement
display reappears.
Table of default settings
Setting item Default setting Display
Filter function Disabled
Relative function Disabled
Display update Normal
Display hold Disabled
Range AUTO [
] is lit.
Auto hold Disabled
Maximum/Minimum value Disabled
Peak value Disabled
Auto power save function Enabled [
] is lit.
Automatic backlight deactivation Off
Buzzer Enabled [
] is lit.
% conversion 4-20 mA
dBm standard impedance 600
Ω
Temperature display unit °C
Plus/Minus Judgment Function
for Measurement Value
Disabled
HIOKI DT4281A981-08