Hioki DT4282 - Retaining the Measured Value; Retaining the Measured Value Manually (HOLD); Automatically Retaining the Measured Value When the Value Stabilizes (AUTO HOLD)

57
Retaining the Measured Value
4.2 Retaining the Measured Value
The measured value is retained manually or automatically.
• Manually When HOLD is pressed, the measured value is
retained.
• Automatically When HOLD is pressed and held for at least 1
second, auto mode starts. When the measured
value stabilizes, it is retained.
Retaining the measured value manually (HOLD)
OVER
レンジオーバーCOPY: MEAS_
4-20
dBV
COPY: MEAS_
dBm
HOLDRANGE過負荷検出
OVER
最大入力範囲超え
ΔＴRELMAXSLOW
To retain the measured value,
press
.
( lights up and the
measurement value is retained.)
To cancel the hold state, press it again.
(
goes off.)
Automatically retaining the measured value when
the value stabilizes (AUTO HOLD)
抵抗
FILTERREAD
MEM
COPY: MEAS_DCAdBm インピーダンス変更導通ショート交流電流 ( クランプ入力 )
0adj 後オートホールドマニュアルレンジクランプ（レンジ設定）
Press for at least 1 second.
( lights up.)
When the measured value stabilizes, a beeping
sound is generated and the value is retained.
(
lights up.)
If HOLD is pressed again, or the input signal
exceeds the dead zone threshold again (see
table on the next page), or when the range is
switched internally and the measured value
is stabilized once again, the hold state is
canceled. (
goes off.)
To disable the auto hold function, press it for at
least 1 second again. (
goes off.)
1
2
3
4
5
6
7
Appx. Ind.
HIOKI DT4281A981-08