Hioki DT4282 - 2.3 Using Test Leads

28
Using Test Leads
2.3 Using Test Leads
The L9207-10 Test Lead supplied with the instrument are used for
measurements.
Depending on measurement locations, use our optional
measurement cables. For details on the optional items, see “Options
(sold separately)” (p. 2).
WARNING
• To prevent a short circuit accident, be sure to
use the test leads with the sleeves attached when
performing measurements in the CAT III and CAT
IV measurement categories. (For the measurement
categories, see “Measurement categories” (p. 9).)
• If the sleeves are inadvertently removed during
measurement, stop the measurement.
CAUTION
• To ensure safe operation, use only test leads specied
by our company.
• When carrying out measurements with the sleeves in
place, be careful to avoid damaging the sleeves.
• The tips of the metal pins are sharp and may cause
injury. Do not touch the tips.
HIOKI DT4281A981-08