Hioki DT4282 - Using the Memory Function; Saving the Measured Value (MEM)

65
Using the Memory Function
4.8 Using the Memory Function
The measurement result can be saved and read using the memory
function. Up to 400 data can be saved. Data can also be deleted
arbitrarily.
The saved data can be imported to the PC using the DT4900-01
Communication Package (optional).
Saving the measured value (MEM)
TEMP C
TEMP FVERSION
RESET
０－２０mA電源遮断断線（Ｋ熱電対）####
オートパワーセーブＯＦＦブザーＯＦＦメモリデータクリアメモリデータなし
抵抗
FILTERREAD
MEM
COPY: MEAS_DCAdBm インピーダンス変更導通ショート交流電流 ( クランプ入力 )
0adj 後オートホールドマニュアルレンジクランプ（レンジ設定）
Memory No.
1
Press ( lights up).
Memory mode starts.
This function applies until the power is turned
off.
The memory No. appears (only for the
measurement which can be saved).
2
Select the memory No. to be
saved using
/ .
When the key is pressed and held,
the memory No. can be incremented/
decremented faster.
3
Press to save the
measured value.
When the measured value is saved, the
memory No. for which the value is to be
saved next appears.
Even when the power is turned off, the
memory data are retained.
1
2
3
4
5
6
7
Appx. Ind.
HIOKI DT4281A981-08