Hioki DT4282 - 3.12 Measuring AC Using Clamp-on Probe (DT4281)

51
Measuring AC Using Clamp-on Probe (DT4281)
3.12 Measuring AC Using Clamp-on
Probe (DT4281)
The current is measured using our optional clamp-on probe (9010-
50, 9018-50, 9132-50). To connect to this instrument, the 9704
Conversion Adapter is required. Before using the clamp-on probe,
be sure to read the Instruction Manual which accompanies the
optional clamp.
1
2
3
4
5
6
Set the clamp-on probe and the instrument to the same range.
9704 Conversion Adapter
Clamp-on Probe
Change the range in
accordance with the actual
measurement.
If the range of the clamp-
on probe is changed during
measurement, change the
range of the instrument as
well.
Current
range
Press SHIFT three times: Clamp-on probe mode
1
2
3
4
5
6
7
Appx. Ind.
HIOKI DT4281A981-08