Hioki DT4282 - Page 64

58
Retaining the Measured Value
• If the input signal is too small for the relevant range (dead zone
threshold p. 58), the measured value cannot be automatically
retained.
• If the difference between the current and previous measured
values remains less than the counts in the stable eld of the
table below, the instrument determines the current value has
stabilized.
Dead zone threshold
Function Stable (count)
Dead zone threshold
(count)
AC voltage
1200, 200
(1000 V range)
1200, 200
(1000 V range) *
DC voltage
1200, 200
(1000 V range)
1200, 200
(1000 V range) *
DC voltage + AC voltage
1200, 200
(1000 V range)
1200, 200
(1000 V range)
Continuity check 100 5900
Diode test 80 3520
Resistance
1200, 120
(60 M
Ω
/600 M
Ω
range)
58800, 5880
(60/600 M
Ω
range)
Conductance 1200 1200
DC
µA 1200 1200
mA 1200 1200
A
1200, 200
(10 A range)
1200, 200
(10 A range)
AC
µA 1200 1200
mA 1200 1200
A
1200, 200
(10 A range)
1200, 200
(10 A range)
AC (clamp input) 5% of the range 5% of the range
* No function is available for the mV range.
HIOKI DT4281A981-08