Hioki DT4282 - Page 19

13
Usage Notes
CAUTION
• Do not input voltage or supply current exceeding the
specied measurement range. Doing so may damage
the instrument.
• During the continuity check, diode test, or measurement
of resistance, conductance, or electrostatic capacity,
measurement signals are generated in the terminals of
the instrument. Depending on the target for measurement,
the measurement signal may cause damage.
Seeing “Measurement current” and “Open circuit
voltage” in the accuracy table (p. 81), check, in advance,
that there are no adverse effects of the measurement
current and the open circuit voltage.
Precautions during shipment
Observe the following during shipment. Hioki cannot be responsible
for damage that occurs during shipment.
CAUTION
• During shipment of the instrument, handle it carefully so
that it is not damaged due to a vibration or shock.
• To avoid damage to the instrument, remove the
accessories and optional equipment from the instrument
before shipment.
If the instrument is not to be used for an extended
period of time
IMPORTANT
To avoid corrosion and/or damage to the instrument due to battery
leakage, remove the batteries from the instrument if it is to be
kept in storage for an extended period.
1
Ind.Appx.
7
6
5
4
3
2
HIOKI DT4281A981-08