73
Communicating with PC
Attaching the communication adapter to the instrument
Communication
port
Communication
adapter
USB cable
3
1, 2
4, 5
6
1
Using a Phillips
screwdriver, remove
the screws (2 locations)
from the battery cover.
2
Remove the battery
cover.
3
Attach the
communication
adapter.
4
Reattach the battery
cover.
5
Secure the battery
cover with the screws.
6
Connect the USB cable
to the communication
adapter.
• Connect the cables, being careful to orient each cable correctly.
• During communication, appears in the display.
• When is lit, the operation keys of the instrument is
disabled.
• During communication, do not disconnect the USB cable.
Disconnecting the cable stops the communication. In that case,
a warning is displayed by the PC software. Connect the cable
again.
• It is possible to use the instrument while the communication
adapter is attached, however, the communication adapter is
excluded from the drop-proof.
1
2
3
4
5
6
7
Appx. Ind.
To Next Page
Loading...
