Operating Precautions
6
*IP54 :This indicates the degree of protection provided by the enclosure of the
device against use in hazardous locations, entry of solid foreign objects,
and the ingress of water.
5 : Protected against access to hazard
ous parts with wire measuring 1.0
mm in diameter. Dust-proof type (The penetration of dust cannot be pre-
vented completely, but quantities of d
ust that may hinder the stated op-
eration of equipment or safety
cannot penetrate the enclosure.
4 :The equipment inside the enclosure is protected agai
nst the harmful ef-
fects of spraying water.
• The protection rating for the enclosure of this device (based on
EN60529) is *IP54.
• The Humidity Sensor is not designed to be entirely water- or dust-proof.
Do not use it in an especially dusty environment, nor where it might be
splashed with liquid. This may cause damage.
• The Humidity Sensor is not drip-proof. Water droplets on the grip or
conn
ector may result in malfunctions.
• Although this instrument is designed to resist the ingress of dust and
water, it is not entirely water- or dust-proof, so to avoid shock or dam-
age, do not use it in a wet or dusty environment.
• If used outside the specified environmental ranges for operation (or
stor
age), the sensor accuracy may deteriorate in less than one year,
and accurate measurement may not be possible.
• If used outside the specified environmental ranges for operation (or
stor
age), the operation of the unit cannot be guaranteed.
• Humidity measurement values will be affected by about 3% (hystere-
sis) depending on the state of humidity change (low humidity to high
hum
idity or high humidity to low humidity).
• Take care that the temperature/humidity sensor is not exposed to a
chemical solvent having a high concentration for a long period of time
during use or storage.
• When you will not use the temperature/humidity sensor, store it in a
cool
and dark place sealed together with desiccating agent in the plas-
tic bag in which it came.
• Take care to avoid condensation. In particular, if there is a sudden
chan
ge of temperature (for example moving from a cold place to a
warm one), condensation is likely to occur.
• Testing monitor batteries installed in the unit may possibly be weak.
Replace batteries before extended measurement usage.
• Use only LR6 Alkaline batteries. Using manganese batteries may not
result in accurate measurements or proper communication with the
LR5091 Communication Adapter and LR5092-20 Data Collector.
Avoiding Instrument Damage
To avoid damage to the instrument, protect it from physical shock when
transporting and handling. Be especially careful to avoid physical shock
from dropping.
To Next Page
Loading...
Need help?
General
