Hioki lr5001 - Starting and Stopping Recording

4.3 Starting and Stopping Recording
42
Start recording after installing the logger.
4.3 Starting and Stopping Recording
Start
From the Measurement display, hold the
REC/STOP button for two seconds.
The [REC] indicator and the data count blink.
Note: Continue pressing the button until the
[REC] indicator changes from a blink-
ing to on state.
When the blinking stops and the data count is
zeroed, recording starts.
Logger memory contains the data for two
recording sessions. (Be aware that old data is
erased when starting recording after two
recording sessions.)
After one second, the measurement display
reappears.
Stop Hold the REC/STOP button for two sec-
onds while recording (while [REC] is dis-
played).
[REC] blinks.
Note: Continue pressing the button until the
[REC] indicator changes from a blink-
ing to off state.
[REC] disappears when recording stops.
Start
Stop
If the stop method is set to [OFF] (one-time
recording), recording stops automatically
when memory becomes full.(p.30)
Data can be imported to a computer without
stopping recording.
See: "4.5 Automatically Importing (Saving)
Recorded Data to a Computer, and Graph
Display" (p.45)