3.2 Making Settings on the Logger
30
Setting Range 01/01/2010, 00:00 to 12/31/2039, 23:59
Note: Seconds are not settable. However, seconds are set to zero at the instant the display is switched
a
way from the minute setting.
After the battery has been removed for a long time, or if the clock is
incorrect, reset it.
Stop Method Setting (for when memory becomes full)
1
Press the SET button to display the stop
method setting.
(The [ENDLESS] indicator
appears, and the setting blinks.)
2
Press the (+) and (-) buttons to select
[ON] or [OFF].
3
Press the SET button to accept the setting.
(The recording mode setting is displayed.)
Setting Options
Description
OFF Recording stops when memory becomes full (One-Time Recording).
ON(Default) The oldest data is overwritten when memory is full (Endless Recording).
When memory becomes full during one-time recording, the recorded
data count appears as follows.
When memory becomes full during endless recording, the recorded
data count (equal to the memory capacity) remains constant.
(the Measurement display shows channel mea-
surement value and recorded data count)
(instantaneous value recording display)
(statistical value recording display)
To Next Page
Loading...
