Parameter ITxPT Administration
Multicast TTL Multicast routing (used by ITxPT Service) can be configured here and
is managed by a daemon. The smc routing daemon can be config-
ured to be available on multiple network interfaces and provides the
ability to limit or extend the hop limit of the ITxPT service that tra-
verses routers. In IPv4 multicasting, routers have a TTL threshold
assigned to each interface. Only multicast packets with a TTL greater
than the threshold of the interface are forwarded.
Multicast TTL can be set to any value ranging from 0 to 255. The
default setting is 0.
Enable mDNS reflector Reflect incoming mDNS (used bx ITxPT Service) requests to all net-
work interfaces across routed networks, should be enabled or dis-
abled.
Keep in mind that doing this will also mean that any device in your un-
trusted networks will be able to send mDNS requests into your trusted
networks.
Time Specifies whether the ITxPT Service Time should be enabled or dis-
abled.
GNSS Specifies whether the ITxPT Service GNSS should be enabled or dis-
abled.
MQTT Specifies whether the ITxPT Service MQTT should be enabled or dis-
abled.
NB1601 168 User Manual for NRSW version 4.8.0.103
To Next Page
Loading...
