FMS to IP
Figure 6.55.: ITxPT FMStoIP
On this page you can configure the FMS to IP functionality.
Parameter FMS to IP options
Enable Specifies whether the FMS to IP functionality should be enabled or
disabled.
Multicast period How frequent the FMS to IP multicast is sent. Set to zero to redirect
incoming can messages immediately.
CAN interfaces Select the can interfaces that should be processed (multiple selec-
tion).
Databases Select the FMS to IP databases used to process the can-data (multi-
ple selection).
NB1601 169 User Manual for NRSW version 4.8.0.103
To Next Page
Loading...
