6.7.19. Access Controller WLAN-AP
This section can be used to configure the Access Controller (AC) for NetModule AP3400 access points
devices. The AC is able to generate AP3400 configurations, to push the configuration and to read
current status information of AP3400 devices. The AC can manage up to 15 AP3400 devices. It will
be distinguished between different device states.
Parameter AC device states
discovering The NRSW has a valid configuration for this device but the device was
not discovered
discovered The device was discovered but there is no valid config available
unmanaged The device was discovered, the NRSW has a valid configuration for
the device and is currently pushing the configuration to the device
managed The NRSW was successfully pushing the configuration to the device
and is getting status information
update The device is running the update process
reset The device is performing a reset
lost The communication between the NRSW and managed device was
lost e.g. after a reboot of the managed device.
NB1601 181 User Manual for NRSW version 4.8.0.103
To Next Page
Loading...
