Parameter AC operation parameters
Operation command Selects the operation type which shall be performed. For the list of
parameters for the ’firmware update’ or ‘reset‘ operation see table be-
low
ID The list of found devices where the AC can operate on.
The selected operation will take place of all selected devices listed under ID. After pressing the apply
button the selected operation will be finally performed.
Parameter AC operation parameters - firmware update
Firmware update The possibility to load or delete a FW for the NM AP3400 to/from the
internal storage of the NM Router.
Parameter AC operation parameters - reset
Factory reset Perform a factory reset.
Reboot Perform a reboot.
Restart network Restarts the network interfaces.
Configuration
With the configuration page it is possible to configure an AP3400 itself. It is required to have an unique
ID for the configuration which is the serial number of the device. The device ID will be shown at the
AC status page, and via drop down within the ID field while configuration if the device was discovered.
NB1601 183 User Manual for NRSW version 4.8.0.103
To Next Page
Loading...
