Parameter Wired IEEE 802.1X Client Settings
Wired 802.1X status If set to Client, the router will authenticate on this port via IEEE 802.1X
EAP type Which protocol to use to authenticate
Anonymous identity The anonymous identify for PEAP authentication
Identity The identify for EAP-TLS or PEAP authentication (required)
Password The password for PEAP authentication (required)
Certificates Certificates for authentication via EAP-TLS or PEAP. Can be config-
ured in chapter 6.8.8
Parameter Einstellungen IEEE 802.1X Authenticator
Wired 802.1X status If set to Authenticator, the router will propagate IEEE 802.1X authen-
tication requests on this port to a configured RADIUS server (see
chapter 6.8.2)
Reauthentication Period Time in seconds after which a connected client has to reauthenticate
Authenticator ID This unique name identifies the authenticator at the RADIUS server
Use MAB Activate this option if you want to allow authentication of devices
which are not capable of IEEE 802.1X via MAC Authentication By-
pass. These are reported to the RADIUS server with their MAC ad-
dress as user name and password
VLAN Management
NetModule AG routers support Virtual LAN according to IEEE 802.1Q which can be used to create
virtual interfaces on top of an Ethernet interface. The VLAN protocol inserts an additional header to
Ethernet frames carrying a VLAN Identifier (VLAN ID) which is used for distributing the packets to the
associated virtual interface. Any untagged packets, as well as packets with an unassigned ID, will be
distributed to the native interface.
NB1601 52 User Manual for NRSW version 4.8.0.103
To Next Page
Loading...
