The centrifuge comes with a wide range of functions to support a broad range of applications.
A brief description of each mode of operation is given below.
Brief description Reference
Normal operation
Section 3-2 "Basic
Operation"
Function
Programmed operation
You can save set run parameters in memory
for later use in repeated operation.
Section 3-3 "How to
Use the Function
Selection Area"
Section 3-3-1
"Programmed
Operation"
Step-mode operation
Normal operations can be combined in a
sequence of operations.
Section 3-3-1-3
"Step-Mode
Operations"
Displaying and setting
RCF (Relative
Centrifugal Force)
The centrifuge automatically computes RCF
values from set speed, or speed from set
values, and then displ
computation on the control panel.
Section 3-3-2
"Displaying and
Setting RCF"
ω
2
T operation
The centrifuge computes run time from
speed and sets the ω
2
T value.
Section 3-3-3 "ω2T
operation"
3-1