Hitachi CP100NX User Manual

3-3-1-2 Programmed Operation Procedures
The following describes procedures for "programmed operations" by calling registered run parameters.
This is convenient for using the same run parameters repeatedly.
(1) If the registered program no. is known
Step Touchscreen operation Screen displays and notes
1 Turn on the centrifuge
POWER switch.
The Run screen appears.
2 Press the [PROGRAM] button
in the Function Selection
Area.
3 Press the [Program No.]
button in the Program display
screen.
4 Use the on-screen keypad to
enter the number of the
program you want to call and
press the [Enter] button.
3-3-1-2 Programmed Operation Procedures
●
The Program No. entry
screen appears.
Program No. entry
field
Program display screen
[PROGRAM] button
●
The display again
shows the Run screen.
Program display screen
A run parameter called
from the program
A
run parameter called from the program
[Program No.] button
3-37

Hitachi CP100NX Specifications

General

Brand	Hitachi
Model	CP100NX
Category	Laboratory Equipment
Language	English