Hitachi CP100NX User Manual

Step Touchscreen operation Screen displays and notes
4
 The number of the called program is displayed in the
Program display screen.
 It allows you to set and display run parameters (SPEED,
TIME, TEMP, ACEL/DECEL, ROTOR, USER).
 The Program display screen displays the following data.
For details regarding step mode operation, refer to "(2)
Step-Mode Operation Procedures" in Section 3-3-1-3
"Step-Mode Operation Procedures"
5 Do not change the run
parameters after starting a
run.
 Operate the centrifuge according to the instructions in
Section 3-2-5 "Operation Procedures."
3-3-1-2 Programmed Operation Procedures
NOTE
Reentering (changing) the run parameters (for example,
SPEED, TIME, etc.) after calling a program will cancel a
called program.
Program No.
Remaining run time
for all steps
Total number of
registered steps
Current step no.
3-38

Hitachi CP100NX Specifications

General

Brand	Hitachi
Model	CP100NX
Category	Laboratory Equipment
Language	English