Hitachi DIGITAL 8 VM-D965LE - IEEE1394 Maintenance; For IEEE1394 MAINTENANCE, See Before Servicing (before Initializing EEPROM)

NN
7.1. Data Meintenance
(1) Data Initialize
Before Starting Initial Setting:
¢
Initilizing
EEPROM.
Before
performing
this,
see
"Befor
Servicing"
in
CAUTION.
(See
page
CAUTION-3)
¢
This
item
describes
how
to
initialize
the EEPROM.
Be sure
to
perform
this item
after
replacing
EEPROM
or
the
VCA
circuit
board.
When other
components
are
replaced, normally,
it is
not
necessary
to initialize
the
EEPROM.
«
Be sure
to
perform
the
following
adjustments
after completing
the initial
setting.
e
IEEE1394
ID
No.
input
Method
7.2 Digital Adjustment
7.3 Autofocus Adjustment
7.4. VCR Adjustment
7.5 Stabilizer Adjustment
7.6 Spot Noise Adjustment
7.7 LCD Adjustment
7.8 Color LCD Adjustment
Procedure:
1) Start the MAP.
2) Refer to display 1-6.
3) Press A key.
4) Refer to display 2-1.
5) Press 1 key.
6) Refer to display 2-2.
7) Press Y key to start.
Note: Press N to return to MAIN MENU display.
8) Perform adjustment according to the computer display hereafter.
See "8. Error Messages" if an error message appears on the computer display.
(2) IEEE1394 Maintenance
For IEEE1394 MAINTENANCE, see "Before Servicing" in CAUTION. (See page CAUTION-3)
———__ Display & Figs
Display 1-6 Display 2-1 Display 2-2
MAIN MENU DATA MINTENANCE MENU ( « DATA WRITING »
KKK KKH EER ER EERERERKAER KEK ERER REE EREIIRIA EK RREKKKIEKRIKIKERRERER ER ERAAIKIREEE III KEER RIERA. START TO SEND DATA. (Y/N)
MANUAL ADJUSTMENT PROGRAM DATA MAINTENANCE
FRIAR IERIE RI IRAE II IRR IAI IIIS SSIS.
[A] | DATA MAINTENANCE
[B] | ADJUSTMENT
[Cc] | AUTOFOCUS
[D] | VCR ADJUSTMENT
[E] STABILIZER
[F] SPOT NOISE
[G] Led
[H} COLOR EVF
[ESC] END
Please select [A] - [H] or [ESC]
HII IRE HEIKKI II IERIE SAI II III III ISSA.
[1] DATA INITIALIZE
[2] IEEE1394 MAINTENANCE
{ESC] RETURN TO MAIN MENU
Please select [1] - [2] or [ESC]
F3-6