Hitachi DIGITAL 8 VM-D965LE - Error Messages; Error Massage of Digital Adjustment

8. ERROR MESSAGE
8.1 Error Message of Digital Adjustment
ERROR MESSAGE COUNTERMEASURE
ERROR OCCURRED. IRIS TROUBLE - Check whether or not power ts supplied.
PRESS ANY KEY - Check the values of the iris drive circuit.
- Defective soldering, damage to pattern, etc. in the above circuit.
- Check the iris block and replace it if necessary.
- Check the values in the hall amp circuit.
ERROR OCCURRED ON dax ADJUSTMENT
PRESS ANY KEY - Defective soldering, damage to pattern, etc. in the above circuit.
D RANGE OVER. ERROR ON dax ADJUSTMENT - Check the values in the hall amp circuit.
PRESS ANY KEY. - Defective soldering, damage to pattern, etc. in theabove circuit.
ERROR OCCURRED ON da0 and
da1 ADJUSTMENT
- Check the values in the hall amp circuit and its peripheral
circuits.
- Defective soldering
PRESS
ANY
KEY
damage
to
pattern,
etc.
in
the
above
circuits.
FILE
NOT
FOUND
!!!!
-
The
adjustment
program
(file)
cannot
be
found.
PRESS
ANY
KEY
-
Check
the
adjustment
floppy
disk
and
replace
it
if
necessary.
FILE
OPEN
ERROR
!!!!
-
The
adjustment
program
(file)
does
not
start.
PRESS ANY KEY - Check the adjustment floppy disk and replace it if necessary.
- Check the values of the iris drive circuit.
- Defective soldering, damage to pattern, etc. in the above circuit.
- Supply power again and re-adjust.
PRESS ANY KEY
ERROR OCCURRED ON FDET ADJUSTMENT
- Check the values in the hall amp circuit.
PRESS ANY KEY
- Defective soldering, damage to pattern, etc. in the above circuit.
PRESS ANY KEY
PRESS
ANY
KEY
-
Move
the
camera
further
away
from
the
light
box.
TOO DARK - The subject is too dark.
PRESS ANY KEY - Check the light box.
- Move the camera closer to the light box.
- Supply power again and re-adjust.
- The subject is too dark.
- Check the light box.
- Move the camera closer to the light box.
- Check the values in the hall amp circuit.
- Defective soldering, damage to pattern, etc. in the above circuit.
PRESS
ANY
KEY
:
Move
the
camera
further
away
from
the
light
box.
CAN'T ADJUST WHITE BALANCE - The subject is too bright or too dark.
PLEASE RETRY - Check the light box.
PRESS
ANY
KEY
-
Move
the
camera
closer
to
or
away
from
the
light
box.
- Supply power again and re-adjust.
D RANGE OVER ERROR ON HALL AMP
IRIS CANNOT OPEN ANY MORE
PRESS ANY KEY
E3 - 17