Hitachi DIGITAL 8 VM-D965LE - Digital Adjustment

7.2 Digital Adjustment
Betore Starting Adjstment:
When EEPROM or the VCA circuit board is replaced, initialize the EEPROM, referring to “Data Initialize" then perform
all the digital adjustments.
1) Start the MAP.
2) Refer to display 1-6.
3) Press B key.
4) Refer to display 3-1.
5) Select the number of the required adjustment.
Notes: « If [ESC] (escape) is pressed, the computer's display returns toMAIN MENU display.
¢ To complete adjustment, press the [ESC] (escape) twice to restore the MS-DOS screen and then turn off the
camera/recorder and jig.
(1) Auto Iris Control Adjustment
Purpose:
To set the iris control data.
Incompleted Phenomenon:
The picture becomes too bright.
The picture becomes too dark.
Condition:
Point the camera at the light box without a chart to full the screen (at wide-angle).
Procedure:
1) Refer to display 3-1.
2).Press 1 key.
Perform adjustment according to the computer display hereafter.
See "8. Error Messages" if an error message appears on the computer display.
3) Refer to display 3-2.
4) Press any key to return to ADJUSTMENT MENU display.
5) Turn the power off for 5 seconds and then on again.
——— Display & Figs
Display 1-6 Display 3-1 Display 3-2
MAIN MENU . ABJUSTMENT MENU . ADJUSTMENT FINISHED
KIRKE
RIK
IIK
ERE
EKER
IKI
HE
KEKE
RERRERERR
EERIE
RRRREKK
RE
KEKE
IKIKES
KEREREREEEE
ERE
EERE
PRESS
ANY
KEY
MANUAL ADJUSTMENT PROGRAM ADJUSTMENT
[A] DATA MAINTENANCE [1] AUTO IRIS CONTROL
[B] ADJUSTMENT [2] WHITE BALANCE
{Cj AUTO FOCUS [3] CHROMA GAIN
[D] VCR ADJUSTMENT [ESC] RETURN TO MAIN MENU
[E] STABILIZER L Please select [1]- [3] or [ESC] )
[F] SPOT NOISE
[{G] LCD
[H] COLOR EVF
[ESC] END
Please select [A] - [H] or [ESC]
E3 - 7