Hitachi HA820 G3 Series - LFF Front Panel LEDs and Buttons; UID Button Functionality; Front Panel LED Power Fault Codes

10 Component identification
Item
Description
Status
3
NIC status LED
1
• Solid green = Link to network
• Flashing green (1 Hz/cycle per sec) = Network
active
• Off = No network activity
4
UID button/LED
1
• Solid blue = Activated
• Flashing blue:
◦ 1 Hz/cycle per sec = Remote management or
firmware upgrade in progress
◦ 4 Hz/cycle per sec = iLO manual reboot
sequence initiated
◦ 8 Hz/cycle per sec = iLO manual reboot
sequence in progress
◦ Off = Deactivated
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
2
Facility power is not present, the power cord is not attached, no power supplies are installed, power supply failure has
occurred, or the power button cable is disconnected.
3
If the health LED indicates a degraded or critical state, use iLO to review the system health status.
LFF