Installing a front 2SFF side-by-side drive cage 55
10. Connect the data cables from the drive backplane to the NVMe riser.
11. Install drives or drive blanks.
The installation is complete.
Installing a front 2SFF side-by-side drive cage
About this task
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning
any installation procedure. Improper grounding can cause ESD.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Remove the air baffle.
6. Remove the fan cage.
7. Remove the drive cage blank.
8. Remove the support bracket.
To Next Page
Loading...
