Installing a PCIe network adapter 79
8. Connect the cables.
9. Install the access panel.
10. Slide the server into the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server.
Installing a PCIe network adapter
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
About this task
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment, remove
the power cord to remove power from the server. The front panel Power On/Standby button does not
shut off system power. Portions of the power supply and some internal circuitry remain active until AC
power is removed.
CAUTION: To prevent improper cooling or thermal damage, do not operate the server unless all PCI
slots have either an expansion slot cover or an expansion board installed.
To install the component:
Procedure
1. Power down the server.
2. Remove all power:
To Next Page
Loading...
