110 Hardware options installation
6. CAUTION: Employ industry best practices in managing peripheral cables and power cords secured
in the CMA. These are some of the more important points:
• Leave enough cable slack between the rear panel and the CMA to allow the full extension of the
CMA when the server is extended out of the server.
• However, there should be no excess cable slack inside the CMA; this might cause cable binding
and could lead to cable damage.
• Make sure that the cables and power cords do not extend above the top or below the bottom of
the server to which they are attached. Otherwise, the cables might snag on other equipment
installed in the server when the server is extended from or returned to the server.
Route the peripheral cables and power cords through the cable clamps and/or straps.
7. Close the cable clamps.
To Next Page
Loading...
