Hardware options installation
About this task
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment, remove
the power cord to remove power from the server. The front panel Power On/Standby button does not
shut off system power. Portions of the power supply and some internal circuitry remain active until AC
power is removed.
CAUTION: To prevent improper cooling or thermal damage, do not operate the server unless all PCI
slots have either an expansion slot cover or an expansion board installed.
To install the component:
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Remove the riser cage.
6. Identify and then remove the PCIe blank from the riser cage.
To Next Page
Loading...
